![]() ![]() ![]() Install the shift handle on the newīoot in the same way as it was installed on the old one.ġ. These parts, none are available separately. Have to squeeze the 2 tabs and remove the securing ring. With the oldīoot inverted there is a two tab retainer that hold the boot to the knob. The old shift handle must be moved to the new boot. Once the frame is installed correctly, slightly spread the tabs on theįrame to keep it in place. When this is done, reinstall the aluminum frame, tuck the boot as Tape off the old frame to protect it and use spray adhesive on Next take the new boot and lace the tabs of the new boot thru the Mark theįront of this boot on the inside so that you can match the new boot. Or with a small screw driver, peel these tabs back and remove the boot. The folded over tabs of the existing boot laced thru the plastic frame. DO NOT squeeze the tabs hard, they willĢ. Similar tool, slightly squeeze the tabs inward and push them out at the same Tabs of an aluminum frame that holds the glued in boot, firm. With the boot assembly off turn it upside down, you will see the Tap the shift handle from below with a small piece of wood and a hammer. If it does not come off, invert the boot to make the shifter stalk Use some restraint and care, as it is hard to remove on some Next, with two hands, firmly grasp the shifter knob and pull ![]() The frame and lift it out of the console. First, with both hands, or soft flat implement, push the bootįrame forward toward the front of the car. Scroll down for installation of auto shift boot, armrest cover, gauge hood cover!ġ. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |